[bricud]

Bill,

Thanks for the suggestion. Since your post, I found a racing shop about an hour from me (I live near LaCrosse, WI) who is set up with a full port and flow test bench and will take a look at what I have. Soooo, my plan is to drop in the used engine without mods (other than ECUtune 1v5 and TCU) and take the heads off my extra engine. Have these reworked if reasonable enough, and then put on the lower mileage engine in the car. Other than concentrating on the exhaust ports, is there any specific advice to tell them about porting these heads. I think this will be their first time with these specific heads. Or, should I look to send them to an experienced shop. And where is there one in the midwest?

Thanks,

Brian