02-10-2009, 01:47 PM
|
 |
Collision Refinishing Tech
|
|
Join Date: Aug 2007
Location: Huntingdon, PA
Posts: 2,279
|
|
|
Re: How do I install a new shift module?
There are 2 long trim panels that go along the bottom of the cigarette lighter and ashtray. pry these off and you will see 1 gold screw on each side you need to remove. Next take the shifter bezel off by removing the ashtry so you can lift up on the bezel, also unhook the door lock switch if you have one. Remove the screws at the bottom of the console when you open up the lid at the top. Remove the E-brake handle. then slide the whole console back towards the rear seat a little and then pull up and its off. the shift module shoudld be behind the Ebrake if I remember right.
__________________
Seth
94' Barcelona Red w/ Tricoat black 2-tone AWD Ls - Sold
Mods:AWD conversion/4.44 swap by Budfreak, Custom red interior lights, Custom Satin black dash, Power mode switch, Cold air intake, Permecool tranny filter,Sony xplode 10" sub, Sony xplode 1000w amp, Blitz in-line driver, DDM Tuning 6000k HID's, New paint job/body work by me, 97' Grill, QC shift kit, 17'' MB Motoring rims, 15&20 min mod, front & rear urethane swaybar bushings, Custom fiberglass sub box, Custom red led a/c control unit, perrin lightweight crank pulley, Black wrinkle finish powdercoated intake manifold w/ clear hoses , 02' outback heated/power black leather seats
Soon to come: Fiberglass hood, upholster ALL suede to black leather
Past subies:
92' Pearl White/black top LS-L-SOLD
96' Legacy Outback-TOTALED
99' Legacy Outback Limited 30th anniversary edition-TOTALED
98' Forester L -Totaled
Other toys:
99' Forester S -WRX brake upgrade, soon an 04 wrx motor swap
06' B9 Tribeca-Stock
1982' Yamaha xj650 Maxim
Mods: work in progress
|