But what I understood about the SC kit, is that the pulley is very close to the hood as it is. Also it would allow for a smaller crank pulley, and allow for boost pressure to be adjusted at the SC.
I took a lot of measurements last night, and shaped some rough test pieces. I think i was going to be a bit too low to get the look I wanted with my first design. Also I was afraid that I would have to mount the innercooler to low to make it line up proper.
So I changed my design a bit. I think this is going to be close to how the final piece will look. I will need to modify the the bumper beam I think, but it will leave room for a large innercooler to fit nicely and still have about 7" or so ground clearance