[coguzzi]

Hello folks

so i am doing a manual tranny swap on an SVX motor, but not one of a common nature for this forum, I'm putting a SVX motor into a VW vanagon syncro (AWD vanagon). I'm doing a slighlty different route than normal (normal is adapter plate using VW clutch/flywheel). Im going to be using a subaru fly wheel, pressure plate and mated to VW clutch disc.

I can probably use any 2.5L flywheel i assume

my confusion lies in what i am gonna need for pressure plate. I know for the release bearing i am using it has to be a naturally aspirated (push type) pressure plate. what are people using on the SVx motor that can handle the torque.