Quote:
Originally Posted by sicksubie
I pulled the ABS unit out of my car and have a question now that I am starting to redo the hard lines. I have installed a non-abs master cylinder and running the two front lines will not be that big of a deal, but my question is can I just tie into the proportioning valve mounted on the pass. side strut tower for the rear?
|
Send a pic of the "proportioning valve" I have an abs and factory nonabs svx. In the non abs, the brake lines still run to a ...... something.... in the front passenger side of the engine bay, right where the abs module is. The abs car has the same dealy whopper. If that dealy whopper is the "proportioning valev" then yeah, you can use it. Lol, I hope this post helped more than hurt!