[svxash]

So I bought the ones from Summit and installed one in the rear. I bled the brakes until the new fluid came out. I then pulled off the other rear wheel and installed the bleeder. I got out to check the hose to see if the old fluid had been flushed and the dust cap was blown off and there was brake fluid all over the wheel I had already done!!! I checked the bleeder to see if it was tight and it was. Well come to find out the bleeders were packaged wrong from the factory. The part numbers were ok but they were about 3mm shorter than what the Edelbrock rep said they should be and weren't seating. Anyway they are sending me new ones. I'm glad I noticed the fluid and didn't go for a drive.