Thread: Alarm problem!
View Single Post
  #2  
Old 11-01-2001, 10:54 AM
Aredubjay's Avatar
Aredubjay Aredubjay is offline
Rat Fink Member ~:o)
 
Join Date: Feb 2001
Location: Owensboro, KY
Posts: 11,672
Send a message via ICQ to Aredubjay Send a message via AIM to Aredubjay Send a message via Yahoo to Aredubjay
Registered SVX
Re: Alarm problem!

Quote:
Originally posted by Zeppelin
Hey guys.. I haven't been able to get my alarm to work since I bought my car.. I tried getting it into programming mode several times with no luck.. I even tried arming the alarm manually be locking the doors with the key and no luck there either.. Anybody have any ideas???
Is your car a 92/93 or Later? THe module in the 92/93 is located behind the glove box. The module in the later models is behind the trim, in the trunk, and attached to the rear "speaker" deck on its underside.

Three things could be your culprit: 1) Your unit is simply "fried." 2) there are very few moving parts in the module. They sometimes gum up or oxidize. You can take it out, open it up and use contact cleaner (or, WD-40) to clean the contacts and also the connectors to the harness (both male and female connectors), then, reinstall (of course, test, prior to pinning everything back up. It's a pain if you've got a '92/93 to remove and reinstall) Oh, and while you're at it, you can replace the existing antenna with a heaver (only slightly) and longer piece of wire to increase the range of your remote. 3) The unit is not "there." There are some who've reported that their module had simply been removed by a previous owner.
__________________
Randy Johnson
3rd Registered Member 02-21-2001
First Member to Reach 10,000 Posts
First to arrive at the very first Reading Meet
Subaru Ambassador

1992 SVX PPG Pace Car Replica 110+k
1993 White Impreza L 240+K miles
2001 Legacy Outback Limited Sedan 250+K miles
2013 Deep Indigo Pearl Legacy 3.6R 49+K miles

"Reading is my favorite Holiday"
Mike Davis -- at Reading VI
Reply With Quote