[svxsubaru1]

Last night while i was instaling the poly rear bushings i decided to see if a 1st gen legacy rear sway bar would fit since i had one laying around. I test fitting it both way and it fit in one directon, but the end links were to short to reach the say bar end links. Over all if the bar was larger in diamter you may have clearnce problems with the bar hitting the trunk, but with a hit of a hammer you would easiley have enough clearnece for a bar with another 1/2 inch diameter more than stock. The only question i have is since the end links would have to stick in about 1inch to conect to the end of the sway bar would this cause any binding? I know there are a decent amount of sway bar options for the 1st gen legacys for cheap so we may be able to have a decnet upgrade if we could get we some better end links that would work.