Thread: legacy seats
View Single Post
  #4  
Old 05-25-2008, 09:45 AM
Speedklix's Avatar
Speedklix Speedklix is offline
Locker Link Solution
 
Join Date: Aug 2002
Location: North Shore, MA
Posts: 1,902
Quote:
Originally Posted by YourConfused View Post
I think sucksubie put wrx seats in his svx. the rears were a drop in and the fronts required a little modifying of the rails. I may be wrong though.
WRX seats fit the legacy drop in, niether fit the svx "drop-in" and in both cases (leg and svx) you will lose the fold-down seat by using a wrx as a donor.

Sicksubie, had to mod the rails on his fronts, swap front seatbelt receivers, and only the bottom section of the rears sort-of drop in. The seat-back in the rear actually requires modification as it is taller than the svx seat-back!

...if that helps
__________________
-Mike
ECUTune2v7 - 4.11 5 Speed - Sprung 6 Puck Clutch - D&S Rotors - SS Brake & Clutch Lines - HKS Panel Filter - HeaderBack Exhaust -80GB Hard Drive - GroupN Engine Mounts - - some other "tricks"
[SIGPIC][/SIGPIC]
In progess: track down mystery noise <-identified, paint the new dash, get better pic
Spring plans: Replace Trans - Integrate ECU with the carputer - Suspension - Go back to STI Filter - Paint? Maybe not - Next Oil change: Purolator L30165

Member #995 | My Locker | My New Locker

Catch you next at: ? Auto-X ?

Last edited by Speedklix; 05-25-2008 at 09:48 AM.
Reply With Quote