First trial installation of the external cooler + fan.
I made a bracket/shroud for the puller fan. There were two square holes behind the battery tray - I just pushed plastic nuts in these and use 5mm bolts for the upper stay. Drilled a few holes for the lower mounting. I may have to reinforce the upper bracket a bit - it does flex a little, just to make sure it won't fracture due to fatigue.
The location is a bit risky from winter driving point of view - if I hit a hard snow bank the plastic bumper will give in and may foul with the cooler.
I also bought a separate thermostatic bypass valve for fast warm ups and winter cruising.
The fan will be controlled by a temp gauge with a programmable output for a relay.
These are the parts I bought so far (Summit):
Hayden Fluid Coolers
HDA-679
Fluid Cooler, Transmission, Plate, Natural, 11 in. x 11.625 in. x 0.75 in., 3/8 in. Inlet, Outlet, Each
Perma-Cool Standard Electric Fans
PRM-19128
Electric Fan, Single, 8 in. Diameter, Reversible, 2,400 cfm, Black, Plastic, Kit
Hayden Remote Oil Thermostats
HDA-163
Remote Oil Thermostat, Dual, 3/8 in. Nipple, Each
/T