|
stock front sway bar bushing dimensions
SVXRide asked me to post this:
total depth (incl lip): 1.15"
depth across the clamp area: 0.83"
height of center of hole from bottom of bushing: 1.25"
width across the clamp area: 1.35"
total width (incl lip): 1.67"
height in the clamp area: 1.87"
total height (incl lip): 2.17"
These measurements were taken with a caliper. Depth is defined as the dimension parallel to the axis of hole.
These measurements are off a nearly new bushing. The clamp compresses the bushing a fair amount in the height dimension. I would estimate about 0.13-0.18" of compression.
__________________
Mychailo
:: 2006 Silver Mitsubishi Evolution 9, E85, 34 psi peak, 425wtq/505whp DJ ::
1995 Laguna Blue SVX L AWD 5MT (sold)
Visit my locker
SVX Mods: ND iridium spark plugs, Impreza RS fpr, afr tuned to 13.2:1 using a custom MAF bypass, custom exhaust, WRX 5MT w/ STi RA 1st-4th gear & stock WRX 5th gear, Exedy 13 lb flywheel & Sport Clutch, STi Group N tranny & engine mounts, urethane spacers in rear subframe, rear diff mounts, and pitch stopper, SVX Sport Strut Springs (185f/150r), custom 19 mm rear swaybar, urethane swaybar mounts, Rota Torque 17x8", 225/45-17 Proxes 4 tires, Axxis Deluxe Plus organic brake pads.
Last edited by mbtoloczko; 10-17-2003 at 11:15 AM.
|