[Subafreak]

Originally Posted by SVXRide

Jesse,
does this mean you're going to take a shot at fab'ing the adapters for the Group N mounts (hope so!)?
-Bill (stepping to the front of the "Jesse's custom Group N motor mounts" line )

Well from what I've been reading your just need a 1/4 peice of metal between the top of the mount an the mounting plate, but from looking at them so far comparing a broken mount and stuff, it would seem like useing the SVX mounting plate is the way to go becouse it bolts to the motor with three bolts instead of only two, plus the mounting plate that comes with the mounts would put the mount in the wrong spot. So with that being said the group N-mount does not fit in the stock mounting plate at all, the bolt spread is different and it seems like it needs more that a quarter inch to clear the edges of the mounting plate, so I may need to grind down the sides of the mounting plate along with elongating the bolt holes. But it's hard to tell for sure with out having a good stock mount at the moment to compare mounting hight and location. I'm sure I could whip out a hundred 1/4" aluminum spacers with two holes in them but you would still need to take out the mounting plate and do some grinding..........thats the way it looks right now anyway.