05-18-2013, 06:57 PM
|
|
Collision Refinishing Tech
|
|
Join Date: Aug 2007
Location: Huntingdon, PA
Posts: 2,279
|
|
No speedometer
Well swapped my trans a couple days ago and now my speedo doesn't work. Pulled the lock plates off the axles and both plastic gears are intact. BUT when I lift the car and put it in drive it doesn't engage the other gear. I re-tightened the plates on both sides and did it again and nothing. Any ideas? I thing the shaft is bent but how do you get it out of the bellhousing from the top?
__________________
Seth
94' Barcelona Red w/ Tricoat black 2-tone AWD Ls - Sold
Mods:AWD conversion/4.44 swap by Budfreak, Custom red interior lights, Custom Satin black dash, Power mode switch, Cold air intake, Permecool tranny filter,Sony xplode 10" sub, Sony xplode 1000w amp, Blitz in-line driver, DDM Tuning 6000k HID's, New paint job/body work by me, 97' Grill, QC shift kit, 17'' MB Motoring rims, 15&20 min mod, front & rear urethane swaybar bushings, Custom fiberglass sub box, Custom red led a/c control unit, perrin lightweight crank pulley, Black wrinkle finish powdercoated intake manifold w/ clear hoses , 02' outback heated/power black leather seats
Soon to come: Fiberglass hood, upholster ALL suede to black leather
Past subies:
92' Pearl White/black top LS-L-SOLD
96' Legacy Outback-TOTALED
99' Legacy Outback Limited 30th anniversary edition-TOTALED
98' Forester L -Totaled
Other toys:
99' Forester S -WRX brake upgrade, soon an 04 wrx motor swap
06' B9 Tribeca-Stock
1982' Yamaha xj650 Maxim
Mods: work in progress
|