[Cam]

Unfortunately today, I was checking my run-out on the crank. I believe at #6 bearing the crank was showing .0015-.0002" of run-out. It was hard to tell because the front bearing (only 1 and 5 were inserted) kept slipping and following the crank out of the cage. Regardless, the needle moved so I am going to be double checking it to verify it is not out of round, and then I will have a few choice words with the machine shop. I do not know if I will take it back to the same guys, after they took .006" of my decks on my block without calling me first.

On the bright side, a few pics!