timing advance
thanks for the input. on page 3 of section 2.2 of the factory service manual, it says,"ignition timing [BTDC/rpm]:20º ± 8°/610"
OK then, what i understand about this is, up untill detonation, the more advance the better so that the flame has time to burn the air gas mixture and has its maximum pressure at tdc. in comparison to other engines the subarus have a very conservitive timing map. on my 92 , with the newly installed headers, the select moniter shows a timing retard of up to 10 degrees, the timing advance goes up to 50 advance. when i tip in on the throttle, the timing retards, possibly due to the slightly louder exhaust, causing the spaek knock sensors to react.
when the timing retards the engine goes off song, and power drops off as well. i know i can insulate the 2 knock sensors, but that takes away a very good safeguard.
|