Re: Tacho needle barely moves past 1000 rpm!
Quote:
Originally Posted by andreoz
Hi Harvey, Is the crank sensor easy to find if I want to trace the wire through to the tacho to see what may be the issue. It sounds a bit like a resistive joint or similar causing a recalibration. Many thanks for your advice. I am still to put in the Quick Change! The car is a pleasure to drive again after replacing the rear bearings
|
The taco reads the RPM signal from the ECU. it also goes to the TCU.
So if the car runs, the crank sensor and the ECU are OK.
So it should be in the dash panel or wiring up there.
I still have your E-Mail addy so I'll send you a scan of the wiring and the dash panel.
Harvey.
__________________
One Arm Bloke.
Tell it like it is!
95 Lsi. Bordeaux Pearl, Aust. RHD.149,000Kls Subaru BBS wheels.
97 Liberty GX Auto sedan. 320,000Kls.
04 Liberty 30R Auto Premium. 92.000kls.
|