I still do not have this sorted.
The connections are all in tact.
The front switch checked out OK
Rear switch is OK
The motor is fine.
I removed the computer and desoldered and tested all the relays and they are all OK. Checked all the solder connections and did a little touch-up, but still nothing.
I am at a loss
I guess it is a problem in the computer silicone logic.
Any other areas to check or test?
I'll put in a request for the part (seatbelt computer) in the correct section of the forum, but if you see this post and have one lying around, shoot me a PM.
Thanx