[Mike621]

Originally Posted by Noriyasu

I've been planning this for a long time, but I'm currently making an engine block coffee table.

Recently I could buy a junk engine for about $7. Unfortunately it's not EG33. It's EJ20.

Once the engine was completely disassembled, it was cleaned and sandblasted.

The top half of the left bank was cut away to reveal the interior and it was assembled once to check the appearance. I'm wondering whether to make an additional cut on the right side. I would like to leave at least the EJ20 marking on it.

Looking great!

What are you planning on using to offset the glass/top from the block? I have seen other designs that use the pistons or other engine pieces to create the offset.