Well unfortunately I decided the engine and trans should be installed before I started on the wiring. That means trans mount version 3.0 had to be made. I needed all the clearance I could get under the car and the last two mounts I made just weren't going to cut it. I welded some c channel rails between the chassis rails on the tunnel and made ears that come through the tunnel. Then made up a new c channel mount for the underside of the car. I think this will provide the support I will need and allow for the clearance required for a 3.5" exhaust to slip by it. Very tight quarters under there but I finally like the way the trans is supported.
Now I can focus on my electrical moving forward until my backordered parts arrive
Tom
Tom