So only a little progress this weekend. I have started to rebuild the trans tunnel prob half a day from being completed. I'm still waiting on some parts to complete my driveshaft measurements. Once I've got that done I can pull my mock up engine and trans so I can disassemble trans and install the new tailshaft housing. I did however get my ball joints installed. Since the sti rack has 14mm inner ends and the taper diameter for the out tie rods was different I had to make something work. I found some gmc work van tie rod ends are the correct length and nearly correct pitch so with a little modification of the spindle they will work well.
More pics when I get a little further
Tom