Hello all,
I had the same problem on my passenger side door and tried several solutions with only temporary success. Then my son did some work with CAD and a 3D printer and now the window goes up and down again.
I attach the drawing and 3D printing files to this message. It is important to use the highest strength plastic possible to print the part. I also coated mine with a layer of JB Weld on the exterior surfaces for extra strength.
Good luck !
Quote:
Originally Posted by SVXandO
I may be mistaken, but I believe a member posted a while back that there are identical sleeve lock regulators on the rear windows... maybe a swap would be a good temporary fix until 3D printing happens...
Someone chime in here, am I misremembering...?
|