Quote:
Originally Posted by Uncamitzi
ok...replaced the crank sensor...nothing... cleared codes ...tried to start the car but i'm still getting the 11 code (no signal from crank sensor for 3 sec after start switch on) that's the only code right now.
Question: looking at the old sensors both the cam and the crank there is some denting on the bottom. Could the part that the sensor senses have come off?
I'll check the wires again... and get a continuity check to see if the wires are good...in the mean time.... I'm still open to suggestions.
|
Seems that there is almost definitely an issue with the wiring if you have tried replacing it with a known good sensor. If the bottom is dented in some way, it is likely to change the magnetic field and how it is reading.