|
Re: Mounts & Bushings.. Subframes & Other Mounts.. .
Yep! .. The creaking/rotational noise went away .. It was the center bearing. YEAH! 
Now.. As I had feared when I took the front driveshaft off the center bearing .. It appears the U-Joint on that front driveshaft is bad. One pivot point was smooth.. the other, sorta smooth in the straight position, but very tight turning either way. Does anyone know about rebuilding these? or buying a used one? cuz all you can buy on SubaruParts.com is an entire 2-piece driveshaft for ~$400! 
I get a droning sound now at about 2000 rpm in Drive .. I think it's the U-Joint!
Thanks..
__________________
Jim
1995 Laguna Blue SVX AWD L - 240K (daily driver) - "ReBuILT" used engine at 236K miles (6/13)
2013 Veloster Red - Driver Now??Dropsprings [1/2" rear, 1" front] with Koni Strut Inserts> Magnaflow Exhaust System> ECUTune Stage 1av1 Upgrade (from 1v4)> ECUTune TCU MOD> Aluminum Crankshaft Pulley> Stainless Brake Lines> Phenolic Spacers> Perforated Brake Rotors (dint like, OEM now)> SmallCar Shift Kit (resting since TCU MOD)> 7-Position Ground System> High-Pressure Fuel Pressure Regulator (resting)> ATF Cooler & Campaign Filter> Yellow Polish Polyurethane Bushings> Pioneer Double-DIN Stereo with JL AUDIO Speakers> Driveshaft Rebuilt with C-Clip U-Joints> 15 Min MOD> 20 Min MOD .. . (2011)
Valentine One Radar Detector with Remote Display - ucan'tseeme! 
|