Quote:
Originally Posted by Freeman
You go to reading yes? You show us all there, yes?
Now that I'm done being Chinese, how much did this cost and where did you get all the parts from? Was everything difficult to wire up or pretty easy? For the love of God, please post a how to for EVERYTHING!
|
Cost:
I think they were like $15-20 each set at autozone.
Each set is two 12" strips, so do front & rear = 2 sets.
+ 6' of 22gauge 2 conductor wire to run the rears, $3
Total cost: ~$45
FLEX LED 24" - Bought at Auto Zone - 3M self adhesive flexible LED strips.
Close to a write up as I can get:
I removed the stock housing and I tapped into the stock floor light on the passenger side:
Stock blub fixture, I removed some of the shielding on the wires, and tapped into it:
Taped it all up so they don't touch and are not exposed:
Passed the drivers side one to the drivers side behind the radio:
I didn't take any pics when I ran the rears. :/
The rears I tapped into the same fixture as the front set, on the front passenger side.
I then ran the wires under the carpet next to center console.
Passed the drivers side one under the center console in the back, under where it opens.
Self adhesive to under the back of the drivers and passenger seat.