[Cam]

Things are picking up now. I have all my parts payed for, and other than the bearings they are either at my house or in the machine shop. Block is being bored and honed, rotating assembly balanced, heads rebuilt with new valve stem seals and a regrind on the seats. I should be starting to re-assemble my engine in a couple weeks so I am pretty anxious. I will be spending A LOT of time in the garage soon. :-) Once everything is running satisfactory and I have a new tranny I will be running it on a dyno and will post results. This will be the second engine to run these pistons. The only other one is dans that I am aware of.

On a side note, I got pulled over on the way to the machine shop...and since I took a deferral just a month ago, I am seriously screwed. Lawyer time...hopefully he can keep it off my record. Wish me luck...