View Single Post
  #2  
Old 05-03-2009, 12:57 PM
Szalkerous Szalkerous is offline
Registered User
 
Join Date: Aug 2001
Location: Nashua, NH
Posts: 255
Send a message via AIM to Szalkerous
Re: AIRBAG light... will it halt an inspection?

FROM SVX_COMMUTER'S OLD LOCKER:

AIR BAG Codes (general only, the FSM has more complete diagnostic procedures.)

2 Short in: front sensor harness, Airbag main harness, and module harness, roll over connector, or faulty control unit.
3 Open circuit in: Front sensor harness or front sensor unit.
11 Fuse #8 blown, faulty control unit, open circuit in main or body harness.
12 Roll connector circuit is open, faulty CU, open AIRBAG codes continued for 1992 SVX circuit in main or module harness.
13 Short in Roll connector circuit or main harness or module harness, faulty CU
14 AB2 & AB7, AB3 & AB8, AB4 AB5 AB6 to CU not connected properly.
21 Airbag Control Unit (CU) is faulty.
23 Power supply short in: main harness, Front sensor harness, roll connector. Module harness damaged, Faulty CU.
31 Fuse #16 blown, open circuit in body harness or main harness. Faulty CU.
Light stays ON- light is faulty, harness to light is faulty, ground circuit fault, faulty CU, AB1 & B58 not connected properly.
Light remains OFF- Blown fuse #15, body harness circuit open, light is faulty, main harness is faulty, faulty CU.




Hmmm..... that doesn't sound good. Is it possible trying to jam the Navigation unit in there, it pulled at the Airbag CU harness??? But then, why now, after having it in there for a year......
__________________
1994 SVX LSi - Black / Beige - 139k miles SOLD!
1999 Chevy Camaro Z28 - Black, 6-speed, hell of a ride.
2004 Chevy Silverado Z71 - Blue LT2 luxury package

Last edited by Szalkerous; 05-03-2009 at 01:00 PM.
Reply With Quote