Security remote....programming question.
I bought an aftermarket remote....I can not seem to get the car to go into programming mode so I can program the remote to the system.
Two different sources have given the following instructions for programming:
1) Turn security switch off.
2) Turn key switch on...then off, leaving key in switch.
3) Immediately turn security switch on....then off, repeatedly until the flashers go on and the horn beeps.
4) Then press the remote four times and the system should accept it.
Doing all this and I can not get the car to get into the flasher/horn thing.
Yet the security system works as it should otherwise.
Am I doing something wrong? What if I disconnect/reconnect the battery and then try it.
Dave
|