A lot of places make adjustable endlinks, you can make your own for cheaper. Either way it doesn't matter if there's nothing to bolt them to.

Anyway, the rear struts won't bolt on. They require the same modifications that other subaru struts require. The mounting tabs are too skinny on non-svx struts by about 5 mm.

The question arises though. Is it safe to adapt the struts to fit? Grind off 1 mm from each of the mounting tabs and 1mm from the knuckle and one should be able to squeeze it on. The mounting tabs are two pieces of metal, about 5mm thick per side, and the hub mounting area is about 29mm thick. Or would it be better to grind 2mm off each side of the mounting area?

The fronts however, have the same measurements.