Quote:
|
Originally Posted by Hellboy
Regrettably (and shamefully), I am the tranny rebuild guy in this case. I've looked through my ATSG manual that came with the rebuild kit and I find a two-line statement that reads "Install the control valve body by engaging the manual valve and manual lever, then tighten the 18 bolts", but I find no pictures. So I've got a couple of questions for you since you obviously know more about this than I do.
Where/What is the manual valve?
How do I engage the manual lever and valve?
Do you have any Guinness?
Thanks for your help,
Hellboy
|
If you pull the pan off, and look up at the valve body, where the shift linkage comes through the side of the box. You will see the manual valve rod with a U shaped end on it,poking out of the valve body. It should hook on to the end of the shift linkage, so that it is moved in and out of the body, as the linkage is moved.
You will have to pull the valve body down again, to get the valve end hooked in the shift linkage.
Harvey.
ps .no Ginness, only Coopers Special Bitter
