Quote:
Originally posted by gl1674
Location: Left (drivers side), on a side wall approx 1/3 - 1/2 height up, just behind (~1 inch) the line between tranny and front diff casing. Access is from under the car, exhaust pipe is in the way - make sure it is not hot. You can get to the ports without removing exhaust, but getting there and looking at the same time is a bit problematic.
You are looking for 3 10mm bolts in a vertical row, all 3 are recessed. You need the middle one. The bolts should have rubber o-rings on them. The other two bolts are also test ports, but I'm not sure what lines they are in... AWD transfer pressure port is somewhere else - at the back of the tranny.
|
Thank you very much. that is much needed information.
However, as I already told Harvey, my English usage sucks. I was actually wondering about a hole from the interior to the transmission so a tech could watch the gauge will in-car. see attached for an example from the Legacy manual.