Hi everybody!

Our try be a full success. The frontlights looks now like new from the factory. As I write up, I want first try with special breakcleaner.

Then I remember, that I have a special electronic cleaner in the house, also from Molyslip. This cleaner is special for electrique and electronic components (also for computermainboards etc.). I use this spray for clean all electronic components and motors from my rc-touringcar (HPI RS4 Pro2), incl. the speedcontroller.
But it's write, it cleans also very good and carefully plastic parts and glass. After use, it's disappear complet. If the surface is very dirty, it can takes a few minutes. Ok, I did so:

I took a little plastic tube and put this on the sprayhead . To have the tube better "under control", I twist around a little pipe cleaner. Then I took the bulp out. After this, I put the tube through the hole from the bulp. Then I spray carefully left, middle and right on the glass. I try to spray up, the liquid goes down self and clean the glass. Then I took the tube out and try to take away (again under help from pipecleaner) with a kitchenpaper the rest from the liquid down on the lights so good how it goes (for dry faster). Then I wait 15 min. and did sprinkle there, where it was stay coat. After all, we go shopping and drive around a few km (or in USA miles ) , so that all the rest liquid disappear complet from the "driving wind" and motor hotness.

The result is more than I ever dream. The glass is full clean, like I buy a new front light. I will now clean the right light the same way. By the way, I clean also all the front and backlights outside with this, I takes away all dirty from environmetal pollution (I think a read a post from one SVX-driver with this problem). I'm complet happy . First of all, it looks perfect, second I save minimum SFr. 700.00 (about $450) for a new frontlight.

For the moment, I don't check to put a picture in my post (somebody help me please ). I made a scan from the spray and the tube for better understanding. I will load then this picture up, when I check how to do.

I think, this will help to many SVX-Drivers. I became in the last few months min. 20 emails from Swiss and German-SVX-Drivers with the same problem. Today, when I saw this spray, I come on this idea.

Greetings to everybody

Kusi