Pinion bearing bolts. If you mean the bolts going through the axle shaftside bearing retainers on each side of the case halves and crown gear assembly: 17-20 ft-lb (sec 3-2, page 100)

Pinion shaft/ gear bolt. If you mean the bolts going through the differential case halves and into the crown gear: 43-48 ft-lb (sec 3-2, page 100)

Rear housing section. If you mean the torque converter case: 25-30 ft-lb (page 99)

Front diff section. Not sure what you are looking for here.

Hope this helps.