View Single Post
  #35  
Old 04-06-2003, 06:36 PM
speedracer speedracer is offline
Registered User
 
Join Date: Mar 2003
Location: Albuquerque, NM
Posts: 40
Send a message via AIM to speedracer
Little help please

Where did everyone go? Please help

Yes, the pin numbers from the schematic. I unplugged them from the fan motor and tested them with some wire.

I just started the car, this is what i got: I started the car, and took the cap off the check water temp.
the temp at reg running temp (according to temp gauge in car, a little less than half way)

The fans never turned on. I turned on the heat and the a/c at full speed, no fan. the temp didn't increase, but there was also lots of water in the rad.

the hose going from the top of the rad to the engine was Hot and soft. The bottom one was not as hot and also soft. I don't know if that means anything, but I just want to put in what i saw.

Last edited by speedracer; 04-08-2003 at 06:40 PM.
Reply With Quote