The Subaru SVX World Network   SVX Network Forums
Live Chat!
SVX or Subaru Links
Old Lockers
Photo Post
How-To Documents
Message Archive
SVX Shop Search
IRC users:

Go Back   The Subaru SVX World Network > Search Forums
Register FAQ Community Calendar Today's Posts Search

Showing results 1 to 16 of 16
Search took 0.75 seconds.
Search: Posts Made By: JakeP
Forum: Technical Q & A 02-02-2016, 02:47 PM
Replies: 21
Views: 7,340
Posted By JakeP
Re: rear differential ratio

Drained tranny fluid, filled with maxlife atf and added lubegard atf protectant. Put fuse in for FWD and FWD showed up on instrument cluster.Weather is terrible right now so no test drive.
Forum: Technical Q & A 02-01-2016, 08:48 AM
Replies: 21
Views: 7,340
Posted By JakeP
Re: rear differential ratio

Guess I got miss-informed, thanks for setting me straight on that. Found exactly what you say in the FSM. Car has been parked for awhile but got a chance to check a few things out yesterday. Put a...
Forum: Technical Q & A 01-23-2016, 08:21 AM
Replies: 21
Views: 7,340
Posted By JakeP
Re: rear differential ratio

The car sat in my shop jacked up and ready to pull tranny for several weeks before actually pulling it. The convertor drained back into tranny. Lost very little fluid when sliding convertor out. Used...
Forum: Technical Q & A 01-22-2016, 06:05 PM
Replies: 2
Views: 1,248
Posted By JakeP
Re: Cold engine idle

Idles at 1500 rpm cold and 700 rpm warmed up.
Forum: Technical Q & A 01-22-2016, 06:02 PM
Replies: 21
Views: 7,340
Posted By JakeP
Re: rear differential ratio

Tranny was not opened up, just convertor seal and propellar seal replaced. Wire to solenoid is plugged in and not damaged. Dexron 3 compatable fluid was used only to top off fluid level. Will try to...
Forum: Technical Q & A 01-17-2016, 02:04 PM
Replies: 2
Views: 1,248
Posted By JakeP
Cold engine idle

Engine fires right up on cold start then stumbles like it is running too rich and clears up after about a minute. Cleaned maf sensor and throttle bores. Air bypass is open with cold engine, do not...
Forum: Technical Q & A 01-17-2016, 01:54 PM
Replies: 21
Views: 7,340
Posted By JakeP
Re: rear differential ratio

No, thanks for asking
Forum: Technical Q & A 01-11-2016, 01:34 PM
Replies: 6
Views: 2,763
Posted By JakeP
Re: Fuse box- door latch solenoid

Security system seems to be de-activated, came with one remote that is dead. Took latch assembly out of door and ended up breaking the plastic rod(by accident) that pushes against the lock. Crude but...
Forum: Technical Q & A 01-03-2016, 07:57 AM
Replies: 6
Views: 2,763
Posted By JakeP
Re: Fuse box- door latch solenoid

Found fuse panel on drivers side kick panel, fuse is good. Power door lock switch on drivers door armrest does not activate either door lock. Passenger door is not locked and locks- unlocks with key...
Forum: Technical Q & A 01-03-2016, 07:29 AM
Replies: 6
Views: 2,763
Posted By JakeP
Fuse box- door latch solenoid

Found fuse box near battery under hood, is there another? FSM does not give info on locations. Says #13 fuse controls power door locks. Drivers door stays locked, had to force key to unlock to open...
Forum: Technical Q & A 12-20-2015, 04:20 PM
Replies: 21
Views: 7,340
Posted By JakeP
Re: rear differential ratio

4. Transfer Clutch Driven Plates (Metal) and Seal Rings - Refer to Figure 4
Modified Clutch Driven Plates (P/N 31589AA041) were installed to reduce rear axle
binding starting with transmission...
Forum: SVX Registration 12-20-2015, 07:30 AM
Replies: 1,268
Sticky: 92 Svx
Views: 756,152
Posted By JakeP
Re: 92 Svx

Jakep Claret ...
Forum: Technical Q & A 12-19-2015, 10:07 AM
Replies: 21
Views: 7,340
Posted By JakeP
Re: rear differential ratio

Thanks, I did find out the rear differential is a 3.90 ratio. Will follow up with what I find causing the bind!
Forum: Technical Q & A 12-16-2015, 01:45 PM
Replies: 21
Views: 7,340
Posted By JakeP
rear differential ratio

Purchased this 1992 SVX several months ago. Have put new steering rack lines on it, removed transmission for new torque convertor seal and rear propellar seal.Previous owner installed a 3.90 Legacy...
Forum: Technical Q & A 11-11-2015, 01:32 PM
Replies: 0
Views: 1,677
Posted By JakeP
TZ102 all wheel drive transmission

Getting ready to pull the tranny and would like to know where the balance point is .I know it is closer to the front. My tranny jack has a 9 inch plate with adjustable arms. Just trying to be safe.
Forum: Technical Q & A 10-08-2015, 05:59 PM
Replies: 0
Views: 1,132
Posted By JakeP
steering rack

In process of replacing steel pipes on steering rack. There are two feed lines which I assume are double flare joints. The remaining two are listed as inlet from pump and outlet to pump tank. Have...
Showing results 1 to 16 of 16

 
Forum Jump

All times are GMT -6. The time now is 12:14 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
© 2001-2015 SVX World Network
(208)-906-1122