Forum: Technical Q & A
03-04-2023, 09:47 PM
|
|
Replies: 12
Views: 3,155
Re: ABS Issues post manual install
A GD Impreza pedal assembly and booster work great. Get the booster vacuum line from the Impreza also, it has a hard 90⁰ to face in the correct direction.
|
|
Forum: Technical Q & A
02-22-2023, 12:40 AM
|
|
Replies: 12
Views: 3,155
|
|
Forum: Technical Q & A
04-14-2022, 08:39 PM
|
|
Replies: 2
Views: 1,297
Re: Warning-Power steering pump bracket FAILURE
I have never seen one cracked or damaged unless hit during an accident. I do see the long adjuster bolt broken either from corrosion or improper use. It is quite a thick cast aluminum part and I...
|
|
Forum: Technical Q & A
08-17-2021, 11:54 AM
|
|
Replies: 5
Views: 1,565
Re: Dash lights on, no power steering
Sounds kind of like a belt issue. Pop the hood and make sure the belt is on and tight and also check to see if the idler is seized. The Christmas tree lights on the dash is indicative usually of an...
|
|
Forum: Technical Q & A
12-04-2020, 06:42 AM
|
|
Replies: 15
Views: 4,413
Re: 1994 Subaru SVX - Starting problem
To me it almost sounds like a coolant temp sensor issue. When the engine is still completely hot it is fine, and when it is cold it is fine, but if there is a dead spot in the middle temp range the...
|
|
Forum: Technical Q & A
11-11-2020, 06:18 PM
|
|
Replies: 7
Views: 1,257
Re: Help with plug / connector ID
As you can see in this picture the wires from the connector pass through into the wheel well. These connect to the ABS sensor on the knuckle.
20170
|
|
Forum: Technical Q & A
11-08-2020, 06:56 AM
|
|
Replies: 7
Views: 1,257
Re: Help with plug / connector ID
That's the connector for the ABS sensor for the front left wheel. One of those wires should pass through into the wheel well. There should be one in an identical location on the right side of the...
|
|
Forum: Technical Q & A
07-23-2020, 04:55 PM
|
|
Replies: 6
Views: 2,673
Re: Retro-fitting a CAN bus to a pre-OBD2 SVX?
Any of the major names make good ECUs, Halltech, ECUmasters, Motune, etc. Most of the new ones have electronics that will display anything and everything you could ever want. You would not have to...
|
|
Forum: Technical Q & A
07-22-2020, 02:29 PM
|
|
Replies: 6
Views: 2,673
|
|
Forum: Supercharged Projects
02-06-2020, 12:09 PM
|
|
Replies: 1,352
Views: 556,406
|
|
Forum: Interior Mods
11-29-2019, 01:09 PM
|
|
Replies: 3
Views: 7,465
Re: Seat rails from Japan
Planted makes seat brackets for the SVX here in the US. Then you can use sliders or mounting brackets to match whatever aftermarket seats you are using.
It is definitely interesting that Recaro...
|
|
Forum: Supercharged Projects
09-28-2019, 10:37 AM
|
|
Replies: 1,352
Views: 556,406
|
|
Forum: Supercharged Projects
09-25-2019, 03:50 PM
|
|
Replies: 1,352
Views: 556,406
|
|
Forum: Technical Q & A
07-06-2019, 01:09 PM
|
|
Replies: 22
Views: 7,470
|
|
Forum: Technical Q & A
07-05-2019, 10:48 PM
|
|
Replies: 22
Views: 7,470
|
|
Forum: Technical Q & A
07-05-2019, 01:06 PM
|
|
Replies: 22
Views: 7,470
Re: Damn wheel bearings!!!!
Do you use a press, or a hub shark tool when you do the bearings? The appropriate method that Subaru has changed to is the hub shark tool. It allows the bearing to be done with the knuckle in the...
|
|
Forum: Technical Q & A
04-29-2019, 01:48 PM
|
|
Replies: 17
Views: 4,757
Re: Intake sub gear
In the long run I could picture possible camshaft gear damage. I could also picture damage and accelerated wear to the camshaft "bearing" journal surfaces.
|
|
Forum: Technical Q & A
02-16-2019, 03:26 PM
|
|
Replies: 18
Views: 6,146
Re: 3.7 / 3.54 rear diff
The front diff of all 6MT transmissions is a 3.9 ratio. The older ones use a 1:1 center ratio requiring a 3.9 rear diff. The newer ones use a 1.1:1 center ratio requiring a 3.54 rear diff.
The...
|
|
Forum: Transmission and Drivetrain
02-07-2019, 10:36 PM
|
|
Replies: 60
Views: 33,446
Re: Crazy_Pilot's 6MT Swap (Lots-O-Pics!)
I ended up getting a MapDCCD unit because I couldn't find anywhere to physically fit the DCCDPro unit that I had into the car. I used a method I saw from another member and hard mounted the MapDCCD...
|
|
Forum: Technical Q & A
02-07-2019, 05:36 AM
|
|
Replies: 60
Views: 13,823
|
|
Forum: Technical Q & A
01-21-2019, 04:33 AM
|
|
Replies: 18
Views: 3,016
Re: OEM amplifier question
It's part of the headunit iteself. The CD unit is only a CD. And there is no external amplifier. If the speaker works correctly when connected to a different souce, and the wiring connection to the...
|
|
Forum: Technical Q & A
12-21-2018, 05:02 AM
|
|
Replies: 96
Views: 39,304
Re: Trunk Fuel Resistor
That wire looks like a transmission ground wire from a Subaru that is not the SVX. The transmission ground in the SVX actually has a connector in the middle of it, but the other Subaru models did not...
|
|
Forum: Supercharged Projects
12-18-2018, 03:53 PM
|
|
Replies: 1,352
Views: 556,406
|
|
Forum: Engine Management
12-17-2018, 05:37 PM
|
|
Replies: 290
Views: 87,645
Re: Hydra Nemesis
The Nemesis is still available from Element Tuning. It does work however there are much newer options out there. The Nemesis tech is very old at this point. If I were to do it over now (not 6 years...
|
|
Forum: Supercharged Projects
12-17-2018, 05:33 PM
|
|
Replies: 1,352
Views: 556,406
|
