Forum: SVX Parts For Sale
02-04-2020, 07:28 AM
|
|
Replies: 1
Views: 2,306
SVX motor and starter
Motor $50: I bought this motor and installed while I rebuilt my original one. Rebuilt motor is back in car and I want to get this one out of my garage. It runs fine but its missing a cam angle sensor...
|
|
Forum: SVX Parts For Sale
06-26-2018, 05:11 PM
|
|
Replies: 3
Views: 1,544
Engine for sale
I have an engine I bought to uwse while I rebuilt my original motor. Used it for about 2 months, ran fine. I have since sold my car and have no use for the motor. I just want to get this out of my...
|
|
Forum: Technical Q & A
07-24-2017, 04:43 PM
|
|
Replies: 0
Views: 960
Exhaust leak?
I recently pulled the motor and had heads redone. When I reinstalled I found I have what sure sounds like an exhaust manifold leak. I installed a new gasket but made little to no difference. In...
|
|
Forum: SVX Parts For Sale
03-10-2017, 09:59 AM
|
|
Replies: 4
Views: 1,990
|
|
Forum: SVX Parts For Sale
03-09-2017, 10:05 AM
|
|
Replies: 4
Views: 1,990
|
|
Forum: SVX Parts For Sale
02-21-2017, 10:28 AM
|
|
Replies: 4
Views: 1,990
Starter and 4.44 ring and pinion
I have finished my manual conversion and have a good starter and a 4.44 ring and pinion set left over. If you want any of these they are yours for the price of shipping.
|
|
Forum: Technical Q & A
11-20-2016, 09:52 AM
|
|
Replies: 3
Views: 2,066
Re: Weak cylinder
Thanks for the reply. I decided to take the car to a local shop that specializes in Subarus. They checked it out and said the problem was the motor and tranny had very little play in the rubber...
|
|
Forum: Technical Q & A
11-07-2016, 05:54 PM
|
|
Replies: 3
Views: 2,066
Weak cylinder
Need some help here. I finished installing a manual and when I started it up one cylinder seems to be weak. Not a total misfire. It sounds like a lumpy V8 and you can feel a vibration when under...
|
|
Forum: Technical Q & A
10-09-2016, 10:24 AM
|
|
Replies: 3
Views: 1,791
Re: 4:44 converions woes
If the transmission you have will not work, I have a professionally rebuilt 4.44 with about 12,000 miles on it that I need to get rid of. I decided to put in a manual and have no use for it. Not...
|
|
Forum: Technical Q & A
09-10-2016, 08:45 AM
|
|
Replies: 3
Views: 1,186
|
|
Forum: Technical Q & A
09-08-2016, 06:37 PM
|
|
Replies: 3
Views: 1,186
Throttle cable attachment
I had my engine out and now in the process of reinstalling. Forgot which side of the two intake cams the throttle cable attaches to. I think it goes on the inside (left) cam. Is this correct?
|
|
Forum: Technical Q & A
08-03-2016, 10:19 AM
|
|
Replies: 2
Views: 2,308
Re: Exhaust valves NLA
Thanks for link. They are pretty expensive as it looks like you have to buy full set but at least you can get them.
|
|
Forum: Technical Q & A
08-02-2016, 03:21 PM
|
|
Replies: 2
Views: 2,308
Exhaust valves NLA
I was going to have heads R&R'd but when I called shop that was going to do work, he said exhaust valves were NLA. I called Subaru and they confirmed. Has anyone cross referenced the Subie number...
|
|
Forum: Technical Q & A
07-20-2016, 04:56 PM
|
|
Replies: 1
Views: 1,470
Head repair.
I have a cylinder with low compression. Not sure if it a head gasket although water temp is fine, no coolant leak that I can find and no white exhaust. So likely a valve problem. Does anyone know...
|
|
Forum: Technical Q & A
07-20-2016, 04:53 PM
|
|
Replies: 5
Views: 1,249
Re: How do you unplug coil connector?
The male connector has a tab that snaps over a small tab on the top of the female connector. You need to lift that tab up so it can slide over the top of the tab on the female connector.
|
|
Forum: Technical Q & A
07-17-2016, 09:47 AM
|
|
Replies: 5
Views: 1,249
|
|
Forum: Technical Q & A
07-15-2016, 06:42 PM
|
|
Replies: 5
Views: 1,249
|
|
Forum: Technical Q & A
07-07-2016, 08:42 AM
|
|
Replies: 2
Views: 1,221
Re: Engine removal?
It certainly looks like it would be a PITA but pulling motor not a fun job either. I'll probably go ahead and pull the motor as it will be certainly be much easier to work on.
|
|
Forum: Technical Q & A
07-06-2016, 02:58 PM
|
|
Replies: 2
Views: 1,221
Engine removal?
Is it possible to change head gasket without pulling motor? Bad gasket is on right side so a little more room over there.
|
|
Forum: SVX Parts For Sale
06-22-2016, 03:51 PM
|
|
Replies: 13
Views: 4,842
Re: Struts, new in boxes.
My apologizes Mike. I didn't look in bottom of 2nd strut box. All the parts there. Sorry for posting the first posting. I'm good to go.
|
|
Forum: SVX Parts For Sale
06-22-2016, 02:47 PM
|
|
Replies: 13
Views: 4,842
Re: Struts, new in boxes.
Mike,
I received the struts last week and and started installation today. It was my understanding that there were more parts besides just the struts (+ the boots, + the helpers/stoppers + the upper...
|
|
Forum: Technical Q & A
06-02-2016, 09:28 AM
|
|
Replies: 10
Views: 3,459
|
|
Forum: Technical Q & A
06-01-2016, 09:16 AM
|
|
Replies: 10
Views: 3,459
|
|
Forum: SVX Parts For Sale
05-16-2016, 09:40 AM
|
|
Replies: 13
Views: 4,842
Re: Struts, new in boxes.
You sent me a message about getting shipping costs but I can't seem to find it anymore. I'm in the Portland, Oregon area.
|
|
Forum: SVX Parts For Sale
05-15-2016, 10:12 AM
|
|
Replies: 13
Views: 4,842
Re: Struts, new in boxes.
Still have these? I'm in the middle of a manual install and would like to redo the front struts. Mine are pretty tired. Feels like a boat when going over large bumps.
|
