Forum: Technical Q & A
03-19-2011, 09:33 PM
|
|
Replies: 11
Views: 1,608
Re: oxygen sensors.
So I just finished installing a set of the universal Bosch sensors. I did the clear codes procedure but both o2 sensor codes still remain. Any thoughts?
|
|
Forum: Technical Q & A
03-13-2011, 12:00 PM
|
|
Replies: 8
Views: 1,212
|
|
Forum: Technical Q & A
01-15-2011, 02:00 PM
|
|
Replies: 15
Views: 4,092
Re: Foam between the radiator and condenser
That piece of foam on the bottom can become a real problem if it is not removed periodically to clean the crap that collects there. It holds moisture which rots the power steering cooler loop. I...
|
|
Forum: Technical Q & A
05-08-2010, 03:02 PM
|
|
Replies: 18
Views: 4,068
|
|
Forum: Technical Q & A
05-05-2010, 09:24 AM
|
|
Replies: 18
Views: 4,068
|
|
Forum: Technical Q & A
05-02-2010, 06:55 PM
|
|
Replies: 18
Views: 4,068
Re: reprograming a remote keyless
I just went through this with the same problems, eventually realizing you need to be quick about it all. The only difference is I get no parking light flashes. In fact my lights have never flashed...
|
|
Forum: General SVX Babble
01-10-2008, 09:33 AM
|
|
Replies: 5
Views: 987
|
|
Forum: General SVX Babble
01-10-2008, 09:22 AM
|
|
Replies: 5
Views: 987
Lititz Sighting
Not mine. I,ve got a '92 Pearly, although that car has been seen passing through Rothsville. I'm in Millway. There is also a Pearly I have seen heading from Lititz to Manheim. Has a nose bra.
John
|
|
Forum: Technical Q & A
07-26-2007, 10:44 AM
|
|
Replies: 12
Views: 1,855
Fresh Air
Fortunately I just had all of that apart. The top connection on the F connects to the bottom of the intake hose before the throttlebody, or more precisely to the chamber at the throttlebody...
|
|
Forum: SVX Parts Wanted
06-20-2007, 10:39 AM
|
|
Replies: 5
Views: 1,175
Used Calipers
I'm working on rebuilding my brakes with new rotors and pads, but have found two pistons frozen just in the front ( one in ea.). Since you have a bunch of calipers that you would like to see gone, PM...
|
|
Forum: Technical Q & A
12-05-2006, 08:09 PM
|
|
Replies: 5
Views: 1,390
Lock-up
I get the temp and speed combination but is there a way to fool it into locking up sooner? My daily commute is 17 miles, all highway, and now that the temp has dropped the TC never locks. Its killing...
|
|
Forum: Technical Q & A
09-23-2006, 11:52 AM
|
|
Replies: 10
Views: 1,102
I had the same problem after I repaired the...
I had the same problem after I repaired the cooler on my ps. Be sure to do the ps filling and bleeding proceedure listed under How-to-docs. Also be sure to check and refill with the engine OFF. That...
|
|
Forum: Technical Q & A
09-07-2006, 03:14 PM
|
|
Replies: 1
Views: 923
Steering Rack Problem?
After installing my trans oil cooler, I was checking for leaks and noticed that there is a slight amount of play, in and out, where the ty-rod is connected to the rack. This condition is pretty much...
|
|
Forum: Technical Q & A
08-01-2006, 09:34 AM
|
|
Replies: 22
Views: 4,384
|
|
Forum: Technical Q & A
07-12-2006, 03:39 PM
|
|
Replies: 4
Views: 1,185
|
|
Forum: Technical Q & A
07-12-2006, 03:18 PM
|
|
Replies: 4
Views: 1,185
Power steering fluid cooler.
My power steering fluid cooler has rusted through from leaves etc. laying on top of the foam. Will an oil cooler designed for a motorcycle mounted on the inner fender where the hoses connect to the...
|
|
Forum: Technical Q & A
07-03-2006, 08:16 AM
|
|
Replies: 3
Views: 1,237
Rear Wheel Bearing replacement
I need to replace one of the rear wheel bearings and have seen reference to a tool called the hub tamer. How does one aquire such tool or can it be fabricated? I have access to all kinds of pullers...
|
|
Forum: Technical Q & A
05-05-2006, 08:51 PM
|
|
Replies: 2
Views: 1,180
Power Steering Pump
My power steering ran dry today. I filled it again and ran car to warm fluid to check the level. When I stopped the engine the oil pushed out under the cap and flowed down over the pump and...
|
