Swap passenger seat to drivers side
Can the seat cushions from the passenger side (manual) be swapped to the driver’s side (power)? Will it fit on the seat track? I found a car with a good passenger side seat – hardly any wear at all – just been in the rain!
I have read the How-to about switching upholstery but it was for manual seats. Thanks! |
The passenger's seat will bolt in on the driver's side with no problem. Not sure about swapping just the covers.
-Bill |
Yes, this would involve switching seat cushions from passenger side to drivers so I could keep the power seat option. My wife is short and likes the height adjustable option with the power seats.
|
Subscribed
|
Well, I bought the passenger side seat... I'll keep you posted when I switch the cushions to the driver's side. Hopefully it will work. Worst case I'll just bolt in a passenger seat on the driver's side and convert to manual. :D
|
How about getting a power seat from a right-hand drive car and putting that on the passenger side (two power seats)? Has anybody done that?
|
Quote:
|
Wiring?
Quote:
Lee |
that part is eazy i believe the only thing that runs to the seat is a power wire (not sure no svxes near by) because all the controls are on the seat its self
|
RHD power seat option
Guys - see the link below, I have bought quite a few things from this guy in NEW ZEALAND who is wrecking 2 SVXs.(his name is Peter)
http://www.trademe.co.nz/Trade-Me-Mo...sories/Subaru/ Exterior/auction-84087006.htm If you guys want anything give him an email at - petersw@ihug.co.nz Since the only wiring going to the seat is the power-in connector, then all you need to do is splice into the existing power supply (after all how often are you likely to want both seats moving at the same time - eg possibly overloading the supply & blowing a fuse?). |
All times are GMT -6. The time now is 04:48 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
© 2001-2015 SVX World Network
(208)-906-1122