The Power Light is Flashing
My name is Adam Thompson, I live in central Ohio and that power light is flashing. I checked with a Subaru dealer and they said that they couldn't work on it because it's more than 7 yrs. old and they have no experience with them. So I am asking for help. I need to know who will work on my car.
Thanks, Adam Quote:
|
The search here is a great tool...
Stolen shamelessly below from a post by Aredubjay: Here is the procedure for extracting error codes from your TCU. The 16 blinks just means that there is a code being stored. You'll have to run the self diagnosis to actually see what that code us. The "Power" light indicates transmission codes. The following self diagnosis will show any fault codes for the transmission. To perform the self diag test for EXISTING problems 1) Warm up engine by driving at speeds greater than 12mph. 2) Stop vehicle and turn ignition switch OFF. 3) Turn ignition switch ON and make sure POWER indicator lamp comes on. 4) Turn ignition switch OFF. 5) Move selector lever to D and turn manual switch ON. 6) Turn ignition switch ON. 7) Move selector lever to "3" and turn manual switch OFF. 8) Move selector level to "2" and turn manual switch ON. 9) Move selector lever to "1" and turn manual switch OFF. 10) Partially depress accelerator pedal (to turn idle switch off). 11) Check code as displayed on POWER light. Blinking once every 1/4sec is normal. To perform the self diag test for PREVIOUS problems 1) Warm up engine by driving at speeds greater than 12mph. 2) Stop vehicle and turn ignition switch OFF. 3) Turn ignition switch ON and make sure POWER indicator lamp comes on. 4) Turn ignition switch OFF. 5) Move selector lever to "1" and turn manual switch ON. 6) Turn ignition switch ON. 7) Move selector lever to "2" and turn manual switch OFF. 8) Move selector lever to "3" and turn manual switch ON. 9) Move selector lever to "D" and trun manual switch OFF. 10) Partially depress accelerator pedal (to turn idle switch off). 11) Check code as displayed on POWER light. Blinking once every 1/4sec is normal. Trouble codes: 11 Duty solenoid A 12 Duty solenoid B 13 Shift solenoid 3 14 Shift solenoid 2 15 Shift solenoid 1 21 ATF temp sensor 22 Atmospheric sensor 23 Engine revolution signal 24 Duty solenoid C 25 Engine torque control signal 31 Throttle sensor 32 Vehicle speed sensor 1 33 Vehicle speed sensor 2 ---------------------- Long blinks are counted as 10's and short blinks are counted as 1's. In other words, two long blinks and two short blinks would be a code 22. One lone blink and one short blink would be a Code 11 (which is likely what you'll get, but, check it anyway). Good luck. VK |
love that search button
noticed mine is giving me the 16 blinks too upon
start up... going to see whats up with it tomorrow... Cars running great, nothing else going on with it. |
I'm betting on error code 11.
|
Does it have the ShiftKit installed?
Is it all the time or just at start-up? |
Quote:
and no shift kit installed or unplugged parts It does have one of our rebuilt transmissions in it with a built in shift kit, HD cluthes, etc installed |
All times are GMT -6. The time now is 03:24 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
© 2001-2015 SVX World Network
(208)-906-1122