How tough is it to replace valve cover gaskets?
Both sides are leaking, dos'nt look like a lot of room to work. Any tricks besides having "small" hands?...LOL
Also I don't have rear wheel drive, fuse is in, where's a rear drive servo? have looked under the car on the tailstock but I'm not seeing it...HELP!!! |
Re: How tough is it to replace valve cover gaskets?
Check the "How-To Documents", I believe there is a write up on replacing them.
-Bill |
Re: How tough is it to replace valve cover gaskets?
Quote:
If there is, its hidden. |
Re: How tough is it to replace valve cover gaskets?
If you go to the main page scrool down to Faqs and how to's it's there.
|
Re: How tough is it to replace valve cover gaskets?
Quote:
Look through this post, http://www.subaru-svx.net/forum/showthread.php?t=44396 begin from #15 and go forward from there. |
Re: How tough is it to replace valve cover gaskets?
Gotcha. Just didn't see a link to it in the How-To documents.
|
Re: How tough is it to replace valve cover gaskets?
Get a spanner with the ratchett bit in the end. Tell you what that saved alot of time and fitted in the tight gap easly :)
|
All times are GMT -6. The time now is 06:10 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
© 2001-2015 SVX World Network
(208)-906-1122