group n/ stock WRX motor mounts
how did you guys get the mounts to work??? I personally haven't had a chance to look at it yet but when my new motor got put in by the subaru dealer in salt lake I had the reg WRX mounts that I had purchased and gave them to replace them and they said that they didn't work.... is there some sort of modification you guys did to get them to fit??
|
yes, the mounting brackets need to be modified to fit a 1/4" spacer and also they need to be slotted to accept the new bolts
Tom |
what major advantage will this give me compaired to my stock SVX ones??? I know it's stiffer but how much stiffer?? is it noticeable???? what other gain might I get???
|
they don't split nearly as easy. Plus they don't move so much either.
tom |
Who's going to start mass producing the brackets? Ive ruined 2 sets so far trying to make them work but im not "artistic" enough.
I think I read somewhere that huck installed the WRX brackets but it jacks the engine up ¼"? |
I make the brackets and I usually end up selling them with teh GroupN mounts attached. Yes that is true BTW about the wrx brackets
Tom |
would that interfere with my alignment with my drive shaft?? and cause rubbing?? or vibrations??? how much for the set up with the n's??
|
I could make the brackets for $100 a pair or give you the group N's with them for $200. They will not mess with any alignments
Tom |
alrighty I might just have to take you up on a set with the n's next fall so I'll message ya about them then
|
sounds good
tom |
All times are GMT -6. The time now is 05:27 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
© 2001-2015 SVX World Network
(208)-906-1122