Brake Job
I am getting ready to change the discs--my general Subaru tech book talks about getting a special tool to turn the pistons in but the SVX picture looks like the pistons compress normally for the change--any hints or experience out there?
|
Re: Brake Job
Quote:
I just changed my front pads and rotors last weekend and I had no problem compressing the pistons by hand. Just make sure to take the master cylinder cap off and monitor the fluid level so you don't end up with a big mess. Doug |
Use a C-clamp. They're just normal calipers (which are also found on the Nissan pathfinder).
- Ca$h |
Turning the pistons in is only required on calipers that have parking brake mechanisms built into them - something the SVX does not have.
|
Quote:
|
All times are GMT -6. The time now is 12:30 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
© 2001-2015 SVX World Network
(208)-906-1122