Pistons,Rods,Cams for FI Engine
Im looking to build an engine I can call reliable. The stock blocks just dont cut it with a supercharger. Does anyone have these parts anymore? LAN stopped Selling them :(
|
Re: Pistons,Rods,Cams for FI Engine
Call cp.... or any other piston company... ir gonna pay but they will make what you desire... rods... eagle or better will make up a matched mset of 6 for u... valves... brian crower
Tom |
Re: Pistons,Rods,Cams for FI Engine
Click the turbo project link in my sig, that should get you started.
The run down is this though: CP pistons 9:1 CR forged pistons complete with rings and wristpins - $1100 6 take-off STi rods - $100 Cometic headgaskets - can't remember, I think they are like $130 now Unless you want to rev a lot higher (which there's really no reason for) then that should do it. You can also get Eagle H-Beam rods for a reasonable price, but you will have to contact them and get a balanced set of 6. They were unresponsive to my emails though. |
Re: Pistons,Rods,Cams for FI Engine
Arias Pistons are also available, contact Nick Arias III at atomicspeedware.
|
Re: Pistons,Rods,Cams for FI Engine
Quote:
Will i be able to run my 12psi pully with that? I think I have meth injection..havent done much under the hood yet. Also headwork cams,valves,springs...I need more input on the subject please if anyone has it. Quote:
|
Re: Pistons,Rods,Cams for FI Engine
Quote:
|
Re: Pistons,Rods,Cams for FI Engine
Quote:
|
Re: Pistons,Rods,Cams for FI Engine
Manley makes rods too, that's what is in Jack's EG33 Impreza.
|
Re: Pistons,Rods,Cams for FI Engine
OK I want to make sure I got it all...and where to get it from.
Cometic head gaskets - http://www.cometic.com ARP head bolts - ??? (required?) CP pistons - http://www.cp-carrillo.com Aluminum crank/rod bearings - ??? Rods - rallispec.com (eventually) as far as head work I think im going to rock the stock equipment. I haven't found any threads that says it wont work. |
Re: Pistons,Rods,Cams for FI Engine
Quote:
|
Re: Pistons,Rods,Cams for FI Engine
Quote:
for less than $200.00 a pair.:rolleyes: |
Re: Pistons,Rods,Cams for FI Engine
Quote:
If you don't need stronger rods, then stick with the lighter ones. Depends on what you're planning in terms of power. It seems like you're capped to 12 psi, due to the pulley setup. Maybe some ARP rod bolts are a good idea. |
All times are GMT -6. The time now is 04:32 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
© 2001-2015 SVX World Network
(208)-906-1122