Hydra EMS Nemesis II ver. 2.7 RELEASED
Ok so as promised here is the breakdown of the new Ver. 2.7 of Hydra EMS Software and Hardware. As far as when I will start selling them, I'm going to get one in here probably in the next month and start to play around with it and see how it differs from 2.6 so that I can better support those of you who decide to purchase. Also we should still be able to trade in any 2.6 EMS for a Stage III 2.7 Working on IRIS support and VE Maps, VE Base Map will be the only base map that will cost.
Pricing: Hydra Nemesis: Pricing broken down by stage, see below Base Maps: $0 (currently offering for free with purchase, 2 maps, one from Element, and Tom's original 2.6 map converted to 2.7) Torque Control harness upgrade and Map: $50 (not currently offered) Wideband Sensor and Harness: NTK L2H2 kit for $450 extra, and their standard kit for $260 AIT(Air Intake Temp) Sensor and Harness:~$99.95(in development) Hydra 2.7 Specs and breakdown The Hydra2.7 has complete new firmware and software along with new processor with onboard datalogging and new idle, boost control, aux map and long term trim strategies. The 2.7 will also have capability to configure for additional sensors as inputs with configurability. Stage5 Epsilon has built in CAN Bus for use with external dashes, so you can run a dash and tune at same time. Hydra2.7 will be firmware upgradeable remotely without sending the ecu back. Each stage will be upgradeable to the next remotely without sending the ecu back. You can also just buy individual Capabilities if you do not want the next full stage upgrade. Stage 1 Alpha and Stage 2 Beta will be stripped down versions with fewer outputs and inputs then the current Hydra2.5 and 2.6. To get equivalent Outputs as the Hydra2.6, you will at least need the Stage 3 Gamma upgrade Alpha Stage 1(would need to be upgraded slightly to work with the SVX) $1350(OBD1) $1450(OBDII) • 4 injector • 2 inputs,( 1 analogue and 1 digital) • 6 outputs • Knock control • Internal Datalogging Fixed 8 channels Beta Stage 2 $1500(OBDI) $1600(OBDII) • 6 injector • 6 inputs(4 analogue, 2 digital) • 9 outputs • Aux Fuel/Ignition Map • Launch Control • Intake VCT Control • lambda Target • Tip-in Enrichment • injector phasing • Basic boost Control • Staged Injection • Internal Datalogging Fixed 8 channels • Internal Wideband Logging Gamma Stage 3 (equivalent to ver 2.6) $1700(OBDI) $1800(OBDII) • 8 Injectors • 10 inputs (4 analogue, 6 digital) • 14 outputs • Knock control • Aux Fuel/Ignition Map • Launch Control • Intake VCT Control • lambda Target • Tip-in Enrichment • injector phasing • Basic boost Control • Staged Injection • Internal Wideband Logging • Antilag Fuel /Ignition Map • Exhaust VCT • Immobilizer request • Valet Request • Flat Shift • Alternator Control • VE Mode • Alpha N Mode • Boost Compensation • Gear Correction • Individual Fuel and Ignition Trim • STT Ignition Trim • Throttle derivative • 3D maps • Manifold Pressure delta trim • Internal Datalogging Configurable 8 channels Delta Stage 4 $1800 (OBDI) $1900 (OBDII) • 8 Injectors • 10 inputs (4 Analogue, 6 Digital) • 14 outputs • Knock control • Aux Fuel/Ignition Map • Launch Control • Intake VCT Control • lambda Target • Tip-in Enrichment • injector phasing • Basic boost Control • Staged Injection • Internal Wideband Logging • Antilag Fuel /Ignition Map • Exhaust VCT • Immobilizer request • Valet Request • Flat Shift • Alternator Control • VE Mode • Alpha N Mode • Boost Compensation • Gear Correction • Individual Fuel and Ignition Trim • STT Ignition Trim • Throttle derivative • 3D maps • Manifold Pressure delta trim • Internal Datalogging Configurable 8 channels • Steering Load • Traction Control • Coolant Temp RPM Trim • External Map sensor • Engine Speed Delta Trim • Idle speed Error Trim • Calibration Input Maps • Fuel Pressure correction • TPS Position Trim • Barometric Compensation • Fuel Temperature Compensation Epsilon Stage 5 $2000(OBDI) $2100(OBDII) • 8 Injectors • 10 inputs (4 Analogue, 6 Digital) • 14 outputs • Knock control • Aux Fuel/Ignition Map • Launch Control • Intake VCT Control • lambda Target • Tip-in Enrichment • injector phasing • Basic boost Control • Staged Injection • Internal Wideband Logging • Antilag Fuel /Ignition Map • Exhaust VCT • Immobilizer request • Valet Request • Flat Shift • Alternator Control • VE Mode • Alpha N Mode • Boost Compensation • Gear Correction • Individual Fuel and Ignition Trim • STT Ignition Trim • Throttle derivative • 3D maps • Manifold Pressure delta trim • Internal Datalogging Configurable 8 channels • Steering Load • Traction Control • Coolant Temp RPM Trim • External Map sensor • Engine Speed Delta Trim • Idle speed Error Trim • Calibration Input Maps • Fuel Pressure correction • TPS Position Trim • Barometric Compensation • Fuel Temperature Compensation • On Board CANBUS Control( for CAN expansion Box and Dash Support) • Two Internal feedback outputs • Humidity Correction • EGT Correction(requires CAN Expansion Box) • Flex Fuel Support • External Wideband Support • Vehicle Speed Pit Limiter Optional Capabilities • Sensor Calibration maps • Advanced Output Configurations |
Re: Hydra EMS Nemesis II ver. 2.7 RELEASED
Geezus!!!!!
I'm glad this option isn't dead. |
Re: Hydra EMS Nemesis II ver. 2.7 RELEASED
definitely far from dead and more maps soon to come for those who have modified their SVX with bolt ons such as intake, exhaust, headers etc
|
Re: Hydra EMS Nemesis II ver. 2.7 RELEASED
bump... anyone want the best engine management out there??
|
Re: Hydra EMS Nemesis II ver. 2.7 RELEASED
where do i get one of these
|
Re: Hydra EMS Nemesis II ver. 2.7 RELEASED
Give me a call we can order one in for you (801)948-0877
|
Re: Hydra EMS Nemesis II ver. 2.7 RELEASED
New maps available and new harness has been updated to include IRIS functionality directly out of the box. VE Stage II and Stage III maps will be getting designed in the next few months.
|
Re: Hydra EMS Nemesis II ver. 2.7 RELEASED
Until this guy makes good on the intakes, it would not be wise to give him any money.
|
Re: Hydra EMS Nemesis II ver. 2.7 RELEASED
It is not listed on their site, but Phil Grabow at Element Tuning is also able to get the hydra for the SVX. He will be tuning mine this spring so I can dial in the supercharger perfectly.
|
Re: Hydra EMS Nemesis II ver. 2.7 RELEASED
Yes, Phil at Element tuning is the man to go to for Hydra products. Not only is he a stand up guy but he is also very knowledgeable. Please seek him out if you are interested in the Hydra Nemesis for your SVX
Tom |
Re: Hydra EMS Nemesis II ver. 2.7 RELEASED
Another vote here for Phil Grabow. I never used him personally but he has a great reputation among STi folks.
|
All times are GMT -6. The time now is 11:17 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
© 2001-2015 SVX World Network
(208)-906-1122