Transmission mount
Finally putting the built motor back in the car. Silly question though. Its been a while since I've taken out the transmission mount nuts. There are two on each side and one center nut with a rubber backed washer on the center. it seems like it is too thin to fit but up against the bottom of the mount. Anyone know what's going on? It almost seems like the tranny is sitting too low if that is possible. Anyway the rubber backed washer will not fit over the unthreaded part of the bolt. Sorry to not describe this better.
Chuck |
Re: Transmission mount
That is how they are suposed to fit, with a gap between the castle washer and the crossmember.
|
Re: Transmission mount
Awesome. Thanks. Its been a while since I took this off.
|
All times are GMT -6. The time now is 07:08 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
© 2001-2015 SVX World Network
(208)-906-1122