After market exhaust or muffler?
 

Did a search online ... still dont have a decision :(

I see magnaflow mentioned also flowmaster...

I definetly dont want the car to send ricey... any recommendations?

I also have to pick up a set of exhaust tips if I cant make mine look all nice nice

There's always Stebro www.stebro.net but it's a bit more $.

any sound difference?

I've heard the magna flows and in my opinion they sound more ricy then the flowmaster. As for the Stebro, I havn't heard one yet. The flowmaster sounds a little Euro exotic to me. Alittle like a hot ferarri

LOL...I was going to say the exact opposite! :p I find the Flowmasters to be higher pitched like a ricer exaust. The Magnaflows have a deeper quality like a nice V8 and a little more burble. I have heard the Stebro exaust before and to me it is ricey as hell. To each his own. Your best bet is to hold off until a meet if possible and hear the options in person, then decide. :)

Johnny

If I could do it all over again I would stay stock. ANY aftermarket exhaust is going to sound a little ricey. I have a Stebro. It sounds good, but is louder than Christ. I must be getting older....... :rolleyes:

personally go i would go with the muffler. till the tranny goes and 5 or mt is installed (if thats your plan). i redid my whole set up dual no cats not thinking of that. once my tranny goes im redoing mine simalar fixing minor defects (placement and products used). i will have to disconnect all pipes during the tranny swap and renstall or just redo the exhuast. i have awhile before my tranny bites it. so i figure it was a good thing i replaced to run on for at least 2 or more years.

I guess it depends on the set-up. The magnaflows I've heard were full exhaust (with high flow cats & no Resinator). I still have the stock cats and the resinator. Mine is quite a bit quieter then the Magna that I heard.

Is there anyone besides stebro that sells an aftermarket exhaust like maybe in a kit

I thought I saw it on a post here but I cant find it

Anyone familiar with this series of muffler?

http://www.subaru-svx.net/photos/fil...flyr/27624.jpg

Edelbrock

No but you peked my interest. I was hoping to do something like Chike did. He had pics and everything on the thread. Dont know the cost though.

Chop the muffler off and run pipe? :D ?