PnP heads while doing head gaskets
So while I had my engine apart to do headgaskets I decided to sit down with the heads and do some mild port and polishing work, I know its a little rough in some places but my machine shop said they were pretty good for a home job. These are not off the motor in the car but a spare motor.
http://i.imgur.com/z4L3fVCl.jpg http://i.imgur.com/aw7mfjyl.jpg?1 http://i.imgur.com/dIXvZktl.jpg http://i.imgur.com/MbB7w4vl.jpg http://i.imgur.com/ZkXCd03l.jpg?1 http://i.imgur.com/RV3Jnrwl.jpg http://i.imgur.com/dTkJH2Fl.jpg?1 http://i.imgur.com/1SU3QsEl.jpg http://i.imgur.com/KNQOylOl.jpg http://i.imgur.com/uBzd677l.jpg |
Re: PnP heads while doing head gaskets
|
Re: PnP heads while doing head gaskets
Bishop did you ever finish/install this engine? Dyno sheets?
|
Re: PnP heads while doing head gaskets
finished installing the engine, sadly never got a chance to do dyno runs as the radiator failed catastrophically leading to a really bad overheat. I havent had a chance to start digging into the engine yet to see if it failed at the headgaskets or if the heads themselves warped.
|
All times are GMT -6. The time now is 06:46 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
© 2001-2015 SVX World Network
(208)-906-1122