WTB: eg33 valves or heads
 

located in Washington, pm me if you have what im looking for thanks

Re: WTB: eg33 valves or heads
 

I sell complete rebuilt heads, just reuse your cams and lifters...

Tom

Re: WTB: eg33 valves or heads
 

what the price on those

Re: WTB: eg33 valves or heads
 

$500 a pair + $300 core

Tom

Re: WTB: eg33 valves or heads
 

soo if i send you my heads it will cost me 200$?

Re: WTB: eg33 valves or heads
 

no, its $800 and when I get your heads back, you get $300 back

Tom

Re: WTB: eg33 valves or heads
 

If i send you 3 paris of heds wull u gimmy 900$?

Re: WTB: eg33 valves or heads
 

You want just valves? :confused:

Re: WTB: eg33 valves or heads
 

Send them first... then ill let you know:p I have 6 pairs of heads sitting on my shelves

Tom

Re: WTB: eg33 valves or heads
 

depends, my valves arnt sealing and i lapped them very well yet they just wont seal, might just send my heads to a machine shop

Re: WTB: eg33 valves or heads
 

how are you checking your seal?

Tom

Re: WTB: eg33 valves or heads
 

well i had the motor together and i did a cyl. leakdown test and in every cylinder it was leaking near 80-90% and all from the intake/exhaust valves so i took it all back apart and hand lapped the valves and then put a light behind them in the dark and can see light...

Re: WTB: eg33 valves or heads
 

sounds like there is decent deformation on either the seat or the sealing surface of the valve... This can be due to a lot of things, more than likely the valve seats are burned or corroded which I have seen a number of times...

I have a crank to lap valves, but sometimes it will take grinding the valves and/or the seats to make everything right.

At this point, I would take the heads to a reputable machine shop to see about getting a valve job done, or you can buy a pair of my heads and let me deal with the headache.... Up to you

Tom

Re: WTB: eg33 valves or heads
 

bump.....?

Re: WTB: eg33 valves or heads
 

still lookin