Power Window CLUNK!!!!
Ok... my driver window is very shaky at times, and CLUNKS as it
hits the very bottom... Well yesterday I had to replace my window switch cluster, and for the hell of it, rolled my window up/down a few times... come to find out my power window steel cable is looser then a hooker on friday night :eek: :eek: :eek: Anyone have any idea how to tighten this up? I didnt take the plastic off cause i was rushed for time as I had to work last night... But if anyone else has had to do this it makes it easier getting idea's of what exactly I have to do! Thanks in Advance! |
There is an adjuster not down in the bottom near where it wind onto the motor.
|
Quote:
Ok.. Any idea what it takes to adjust it? want to make this as seemless as possable. |
I think it was a couple 10mm open end wrenches - might have been 8mm, could have been 12mm. It is like adjusting the brake cable on an old bicycle.
|
Quote:
Yet another thing getting fixed... now if i can just get an estiment on how much the body/paint and Re-Bending my frame back out will be :-/ |
All times are GMT -6. The time now is 05:11 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
© 2001-2015 SVX World Network
(208)-906-1122