U-Joints from Canada.. for propellor shaft
I put Euro-Drive C-Clip replacement U-joints on my Propellor shaft.. Finally all 3 seemed to work. First time I tried.. it was worse than prior.. probably got needle bearings outta wack??? Had to balance rear section (will probabaly take front section out to balance to completely remove any vibration [small now]). 95% smooth now.. . :eek:
Not easy!!! :D |
All times are GMT -6. The time now is 06:58 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
© 2001-2015 SVX World Network
(208)-906-1122